Publicité
INSTALLATION
The door springs are set at the factory to the proper tension
for the outer door of the dishwasher.
The door spring tension must be adjusted according to the
weight of the custom door panel installed.
1) Turn the adjusting screw with a Philips screwdriver in a
clockwise motion to tighten the left and right door
springs.
2) Turn the adjusting screw with a Philips screwdriver in a
clockwise motion to loosen the left and right door
springs.
The door spring tension is correct when the door remains
horizontal in the fully open position, but lifts up to a close
with the slight lift of a finger.
Check whether the bottom of the door hits the toe kick of
the kitchen cabinet.
•
If the door hits the toe kick, cut the required section out
of the toe kick.
•
Apply silicone or sealant to the cut edge of the kitchen
cabinet toe kick or paint it so that it does not absorb
moisture.
Fig. 19
FIXING THE DISHWASHER INTO THE CABINET
The dishwasher must be secured in place into the cabinet.
Fix the sides with the screws.
Fig. 20
Fig. 21
Fig. 22
21
Publicité
