Viking 5 Serie Guide D'installation page 24

Standoff Bracket Removal
Note: Standoff brackets can only be removed if range is installed against a NON-COMBUSTIBLE wall.
DANGER
FIRE HAZARD
Standoff brackets provide a
3/4" barrier between back of
range and rear wall. These
must be in place for adequate
ventilation. The standoff brackets may
only be removed if range is installed
against a non-combustible wall.
Final Installation
1
Slide range into place. Be sure
anit-tip bracket slides into the anit-tip opening.
3
Check that unit is level side to side
and front to back. The side trim must be 3/8" (0.95 cm)
above countertop. If unit is not level repeat steps 5-7
of "Leveling/Adjustments/Alignment" section.
(48" and 60"W. VDSC Models Only)
1
Unscrew four standoff brackets and remove.
2
Burner caps are packed in styrofoam top pack with the
grates. Place burner on top of range. Place burner
grate on top of burner cap and grate support.
Note: Arrow on burner cap must be pointing towards
c m c m
c m
9 5 9 5
9 5
0 . 0 .
0 .
24
back of range.