Collomix TMX 1000 Mode D'emploi page 22

EN
TMX 1000
TMX 1500
Troubleshoo琀椀 ng
Malfunc琀椀 on
Machine does not start
Machine switches off
after a short time , cannot
be switched on again
Machine does not start
up when filled, remains at
a standstill
* Work on live components may only be carried out by a quali昀椀 ed electrician!
Care and maintenance
The mixer must always be disconnected from the power supply by pulling the
mains plug prior to any maintenance and cleaning work.
Always ensure ease of movement for all moving parts.
The mixer is largely maintenance-free. The drive sha昀琀 is supported by ball bear-
ings with permanent lubrica琀椀 on.
Clean the machine immediately a昀琀 er use. Do not let material deposits dry.
Remove the mixing tool from the hexagon sha昀琀 and clean it outside of the mixer.
Do not tap the mixing tool and mixing tub using a hammer. Bent mixing tools can
lead to damage to the device and poor mixing results.
Replace damaged, bent or worn machine parts.
Treat moving parts, such as the bo琀琀 om segment slidegate, extendable discharge
chute and hexagons sha昀琀 from 琀椀 me to 琀椀 me with spray oil.
22
Cause
• Supply cable too long and/or cable
cross-section too small
• Plug not inserted
• No mains voltage present
• Capacitor defective
• Thermal overload protection trigge-
red (overload of the machine) -
- only for TMX 1500
• Supply cable too long and/or cable
cross-section too small
• Cable was pulled from the mains
plug
• Voltage drop in the power supply
• Capacitor defective
• Mixing quantity too high
• Mixed material too stiff
Remedy
• Check cable cross-section, must be 1.5 mm
shorten supply cable
• Insert plug
• Check mains voltage
• Replace starting capacitor*
• Let machine cool down (at least 2 min), reduce
mix as needed, Press the thermal overload pro-
tection once to reactivate it
• Check cable cross-section, must be 1.5 mm
shorten supply cable, <25 meter
• Insert cable again
• Check mains voltage
• Replace starting capacitor*
• Reduce the material volume
Collomix GmbH
85080 Gaimersheim
,
2
,
2