Collomix TMX 1000 Mode D'emploi page 20

EN
TMX 1000
TMX 1500
Moun琀椀ng the wheels:
Pay a琀琀en琀椀on to the correct installa琀椀on of the wheels. The inside of the wheels is marked with
an adhesive label.
Before you put the wheel on the relevant axle, one of the accompanying washers needs to be
inserted. Once this has been done, a琀琀ach the wheel and one further washer to conclude. Secure
the wheels with the accompanying co琀琀ers as well.
Prior to commissioning
The machine must always be checked for damage prior to each commissioning.
Make sure that the machine is standing securely on a 昀椀rm and level surface. Risk of 琀椀pping!
Electrical installa琀椀on
Check that the voltage indicated on the type plate matches the available mains voltage.
Connect the mains plug of the machine to the power supply socket using a suitable extension
cord (type H07 RN-F, at least Ø 1.5
not connect to standard electrical sockets.
Opening the lid
Pull the release knob with one hand and li昀琀 the lid at the same 琀椀me with the second hand. The lid
is locked when in open state. The release knob needs to be pulled again to close the lid.
Connec琀椀ng the vacuum cleaner
In order to signi昀椀cantly reduce the dust load when 昀椀lling the material and at the start of the
mixing process, we recommend connec琀椀ng a deduster to the hose supports (Ø 35 mm) of the lid.
The deduster used must comply with dust class "M".
Mixing tool
Check whether the mixing tool is correctly mounted and fully seated on the sha昀琀.
If necessary, you can adjust the individual mixing paddles.
20
A
). This socket must feature a residual current device (RCD). Do
2
Collomix GmbH
85080 Gaimersheim

RCD 30mA