Collomix TMX 1000 Mode D'emploi page 19

Collomix GmbH
85080 Gaimersheim
Func琀椀onality
The machine consists of a mobile frame with a permanently mounted mixing bucket made of
steel sheet. A 3-arm mixing tool rotates in the mixing drum around a central drive axis.
Ideally, the mixer is 昀椀rst 昀椀lled with the dry material and then the necessary amount of water is
added to the running machine
The materials are usually mixed and ready for use within three to 昀椀ve minutes. Observe the
informa琀椀on of the material manufacturer and check the mixing quality using a test mixture.
Open the segment slidegate at the bo琀琀om of the bucket to empty the mixer during opera琀椀on.
The rota琀椀ng mixing tool conveys the material to the discharge chute.
Transport informa琀椀on
The machine is delivered on a pallet without wheels. Observe the assembly instruc琀椀ons.
The empty weight of the machine amounts to 131 kg (TMX 1000) /138 kg (TMX 1500).
The machine must always be su昀케ciently secured against 琀椀l琀椀ng and rolling away using several
transport straps for vehicle transport. Non-secured loads can result in serious personal injury
and material damage.
Lash the machine via the lashing eyes with lashing strips of a su昀케cient size.
The lashing eyes are not suitable for transporta琀椀on by crane.
Assembly
The following tools are required for ini琀椀al assembly:
1 x open-end wrench SW 10; 2 x open-end wrench SW 17
Removal of the transport lock:
Loosen the screw connec琀椀ons of the four feet on the pallet. (Open-end wrench SW 10 )
Adjus琀椀ng the height:
Risk of 琀椀pping! Seek the assistance of a second person in this regard.
Loosen the 4 screws on the two front feet using two open-end wrenches SW 17. Tilt the machine
un琀椀l it becomes possible to insert the 4 screws into the upper bores. Then 琀椀ghten the screws
again.
ATTENTION!
ATTENTION!
EN
TMX 1000
TMX 1500
19