Publicité
To add a new passage, click on [Access control].
Next select [Passage management].
Then click on [Add passage].
A
Name the passage
and select the type of operator between the zones from the dropdown list.
Click [Yes] under [Anti-Passback enabled] to enable Anti-Passback for this passage.
Select the two zones the passage will connect from the dropdown menus [Zone 1] and [Zone 2].
Make sure the readers are installed on the correct side of the confi gured passage. This is indicated in the
heading.
Set the module inputs and outputs.
Click [New] to connect the readers to the passage.
G
Name the reader.
Select the ACS01 module connected to the reader.
Select the reader type from the dropdown menu.
Select the connection type.
Select the corresponding port.
For more information on wiring readers, see "How to connect CAME components".
Click on [Add to passage] to save.The reader has been added to the [Reception].
F
E
H
I
J
K
B
C
D
Publicité
