Publicité
REMOVING AND REPLACING THE BLADE
When removing the blade, turn the trimmer OFF. Push the blade away from the
trimmer with your thumb, and the blade will pop off (Figure D). To replace or change
the blade set, fit the plastic tab on the blade set into the notch located at the bottom
of the trimmer opening. Firmly push the blade into the trimmer housing and it will
snap into place (Figure E).
BLADE TEMPERATURE
Due to the high speed nature of Andis trimmers, please check for blade heat often,
especially on close cutting blades. If blades are too hot, dip the blades only into
Andis Blade Care Plus or apply Andis Cool Care Plus and then Andis Clipper Oil.
CARE AND SERVICING OF YOUR ANDIS TRIMMER BLADES
Blades should be oiled before, during, and after each use. If your trimmer blades
leave streaks or slow down, it's a sure sign that the blades need oil. Hold the trimmer
with the blades pointing down to prevent oil from getting into the motor. Place a
few drops of Andis Clipper Oil on the front and side of the cutter blades (Figure F).
Wipe excess oil off blades with a soft dry cloth. Spray lubricants contain insufficient
oil for good lubrication, but are an excellent trimmer blade coolant. Always replace
broken or nicked blades to prevent injury. You can clean the excess hair from your
blades by using a small brush or worn out tooth brush. To clean the blades we
suggest to immerse the blades only into a shallow pan of Andis Blade Care Plus,
while the trimmer is running. Any excess hair and dirt that has accumulated between
the blades should come out. After cleaning, turn your trimmer off and start clipping
again.
USE GUIDELINES FOR LITHIUM-ION BATTERIES
1. The lithium-ion battery included with your trimmer does not develop a "memory
effect" like a nickel-metal hydride (NiMH), or nickel cadmium (NiCd) battery. You
can plug the adapter cord into the trimmer at any time for a full charge, or even
use the battery before a charge cycle is complete. Like most rechargeable batteries,
lithium-ion batteries perform best when used frequently.
2. For maximum battery life, store the trimmer in a partially discharged condition if
the unit will be unused for several months.
3. Do not store trimmer under 50°F or over 104°F. Do not expose trimmer to
excessively damp conditions.
4. Avoid locating the trimmer near heat vents, radiators, or in direct sunlight.
Optimum charging will result where the temperature is stable. Sudden increases
in temperature can result in the battery receiving less than a full charge.
7
Publicité
