Publicité
CHARGING TRIMMER
This trimmer has not been charged at the factory. Please charge the
trimmer for a minimum of 90 minutes before the first use for maximum
performance.
This battery charger is intended for use with Andis model WDT-1 trimmer. Remove
the trimmer and AC/DC adapter from the carton. Plug the adapter into a 120V AC
outlet, or according to your local power standards. Confirm the voltage available at
each overseas location before using the appliance. For connection to a 240V supply,
use an attachment plug adapter of the proper configuration for the power supply
receptacle.
The trimmer must be OFF for the battery to charge. Plug the adapter cord plug
directly into the bottom of the trimmer to start the charging process. The trimmer has
a lithium-ion battery that cannot be damaged by overcharging. We recommend that
the trimmer be unplugged if not in use for seven or more days.
FAILURE TO CHARGE:
1. Make sure voltage is present at the wall outlet (confirm with an appliance you
know is working).
2. Check to make sure adapter cord plug is plugged firmly into trimmer. If failure to
charge still exists, return trimmer to Andis or an Andis authorized service station
for examination.
Battery Status
Low Battery
Warning
Charging
Blade Oil
Travel Lock
Turbo Mode
DIGITAL DISPLAY
Displays percentage of power left in battery until charge is required.
Red plug symbol will illuminate when the battery is less than 10% charged,
indicating charging is needed.
Red plug symbol will illuminate while battery is charging.
Red oil symbol will flash when the blade requires oiling or if excessive hair
is blocking the blade.
Red lock symbol will illuminate while in travel lock mode.
"T" Symbol will illuminate while clipper is in turbo mode.
5
Publicité
