Publicité
All manuals and user guides at all-guides.com
OBJ_BUCH-348-004.book Page 16 Monday, March 23, 2009 3:27 PM
16 | English
Switching On and Off
To start the power tool, push the On/Off switch
4 forwards.
To lock the On/Off switch 4, press the On/Off
switch 4 down at the front until it latches.
To switch off the power tool, release the On/Off
switch 4 or, if it is locked, briefly push down the
back of the On/Off switch 4 and then release it.
Check grinding tools before using. The
grinding tool must be mounted properly
and be able to move freely. Carry out a test
run for at least one minute with no load. Do
not use damaged, out-of-centre or vibrating
grinding tools. Damaged grinding tools can
burst and cause injuries.
Kickback stop
(GWS 11-125 CI/GWS 11-125 CIE/
GWS 14-125 CI/GWS 14-125 CIE/
GWS 14-125 CIT/GWS 14-150 CI)
In case of a sudden drop in speed,
e.g., caused by a jammed disc
while cutting, the power supply to
the motor is electronically inter-
rupted.
To restart the operation, switch the On/Off
switch 4 to the Off position and start the ma-
chine again.
Speed preselection (GWS 11-125 CIE/GWS 14-125 CIE)
The required speed can be preselected with the thumbwheel 3 (also while running).
The data in the following table are recommended values.
Material
Application
Metal
Removing paint
Wood, metal
Brushing, rust removal
Metal, masonry
Grinding
Metal
Rough grinding
Masonry, stone
Cutting
1 619 P07 215 | (23.3.09)
Restarting Protection
(GWS 11-125 CI/GWS 11-125 CIE/
GWS 14-125 CI/GWS 14-125 CIE/
GWS 14-125 CIT/GWS 14-150 CI)
The restarting protection feature prevents un-
controlled restarting of the machine after an in-
terruption in the power supply.
To restart the operation, switch the On/Off
switch 4 to the Off position and start the ma-
chine again.
Reduced starting current
(GWS 11-125 CI/GWS 11-125 CIE/
GWS 1400 C/GWS 14-125 CI/
GWS 14-125 CIE/GWS 14-125 CIT/
GWS 14-150 CI)
The electronic reduced starting current limits
the power consumption when switching the tool
on and enables operation from a 13 ampere
fuse.
Constant Electronic Control
(GWS 11-125 CI/GWS 11-125 CIE/
GWS 1400 C/GWS 14-125 CI/
GWS 14-125 CIE/GWS 14-125 CIT/
GWS 14-150 CI)
Constant electronic control holds the speed
constant at no-load and under load, and ensures
uniform working performance.
Accessory
Sanding disc
Cup brush, sanding disc
Grinding disc
Grinding disc
Cutting disc and cutting guide
(Cutting masonry/stone is permitted
only with use of the cutting guide)
Thumbwheel
Position
2 – 3
3
4 – 6
6
6
Bosch Power Tools
Publicité
