Publicité
English
Always remove the battery before carrying out any work on the power tool.
Condition
Running time is too short
Battery jams when being inserted in power
tool / charger
Battery is not charge even though the light
emitting diode on the charger lights up green
Light emitting diode on charge flashes red
1)
STIHL recommends a STIHL servicing dealer.
20
All manuals and user guides at all-guides.com
Cause
Battery is not fully charged
Life of battery has been reached or
exceeded
Blades sticking / dirty
Guides dirty
Battery too hot / too cold
(1 light emitting diode on battery lights
up red)
No electrical contact between charger
and battery
Battery faulty
(4 light emitting diodes on battery flash
red for about 5 seconds)
Charger faulty
Remedy
Charge the battery
1)
Check battery
and replace
Clean the blades and spray them with
STIHL resin solvent
Carefully clean the guides
Allow the battery to cool down / Warm up
the battery slowly at a temperature
between 15°C and 20°C.
Operate the charger indoors only in dry
locations at an ambient temperature
between +5°C and +40°C.
Remove the battery and refit it properly
1)
Install new battery
Have charger checked by servicing
1)
dealer
HSA 65
Publicité
