Laserworld Club Serie Mode D'emploi page 5

Manual: CS-12.000RGB SN - CS-24.000RGB SN
Content:
1. Product and package contents
2. Preliminary warning notices
3. Initial operations, safety instructions
4. Working on the device
5. Service notes
6. General Operation
7. Operation Modes
Final statement
Technical data
Find information on how to operate your laser here:
https://www.laserworld.com/en/online-manual
page 8 / 28
1. Product and package contents
Please check if all listed parts are included and undamaged. Included in delivery:
Laser system, power cable, key, interlock bridge plug, manual
9
2. Preliminary warning notices
9
1. Please use this device only according to these operating instructions.
9
2. Do not use the device if there are any visible damages on housing, connector panels,
10
power supplies or power cords.
10
3. Never look directly into the light source of a laser projector. Danger of damage to the
11
eyes or even blindness in extreme circumstances!
12
4. This device must not be permanently connected to mains. Disconnect it from mains or use
the power button to switch it off if not in use.
5. Do not operate the device at high humidity, in the rain or in dusty environments.
13
6. The laser device is intended for use in a sufficiently ventilated location. When used out-
28
doors the device has to be protected against standing humidity, overheating and excessi-
vely low temperatures. Note the respective maximum and minimum ambient temperatu-
res for operation specified in the technical details.
Watertightness in accordance with IP54 is only guaranteed if the transparent protective
cover on the ShowNET / FB4 is securely fastened using BOTH screws. If the cover is merely
placed without proper fas tening, resulting in water ingress, this will not be considered a
warranty case.
Any warranty claims are void if the warranty label is removed or tampered
3. Initial operations, safety instructions
1. Make sure to use correct voltage; see in-
formation on device & in this manual.
2. Make sure that the device is not connec-
ted to mains during installation.
3. Installation has to be done by technical
experienced and qualified persons ac-
cording to safety regulations of the res-
pective country.
4. Always ensure that maximum permis-
sible exposure (MPE) is not exceeded
in areas accessible to the public or mem-
bers of staff.
5. In some countries an additional
pection by technical control institutes
English English
Manual: CS-12.000RGB SN - CS-24.000RGB SN
with in any way.
could be necessary.
6. Connect an easily accessible inter-
lock connector or circuit breaker
to the projector.
7. The power supply should be easily acces-
sible.
8. When installing the laser mount it with
a minimum distance of 15 cm from walls
and objects.
9. For safe setup e.g. on walls or ceilings
please use a safety cord. The safety cord
should be able to withstand tenfold the
ins- weight of the device. Please follow the
accident prevention regulations of pro-
page 9 / 28