Publicité
Warning! Risk of injury by pinching!
Do not insert your fingers into the shaded area indicated.
Adjust the height
Open the quick lock and pull the steering column until the bullet clicks into the hole.
Then tighten the quick lock. To adjust the tightness of the quick lock, tighten or
loosen the screw.
4 positions :
• Low: 81 cm
• Middle: 86 / 91 cm
• High: 96 cm
DO NOT FORGET TO REGULARLY TIGHTEN ALL BOLTS AND SCREWS TO
AVOID MISALIGNMENT OR LOSS OF SCREWS.
Care/Maintenance: regular maintenance is a safety commitment
- Wheel bearings: Avoid going through water, oil, or sand, as this can damage
wheel bearings. To look after the wheel bearings, systematically check that the
wheels turn properly by turning the scooter upside-down and using your hand to
spin the wheels. If the wheels do not spin, then they must be removed to check
their condition. First unscrew the wheel axle, remove the axle, and detach the
wheel. Then carefully push the two wheel bearings out of their housing. If they
are chipped or dented, new ones should be bought. If there is no visible damage,
they must then be oiled. To do this, remove all traces of grease, mud, or dust with
a kitchen towel or cloth, and re-oil them with a grease spray or by leaving them to
soak overnight in oil (turn them several times in the oil first). Then reassemble the
wheel bearings and axles, followed by the wheel, onto the scooter. Proceed in the
same manner for the other wheel.
- Wheels: The wheels wear down over time and can be damaged if overly used
on rough surfaces. The back wheel on which the brake is applied is particularly
affected after several hours of braking. In the interests of safety, they should be
checked regularly and changed if necessary.
- Modifications: The original product must by no means be modified except for the
maintenance-related changes mentioned in these instructions.
- Nuts, axles, and other self-locking fixtures: These should also be checked
regularly. They can become loose over time, in which case they should be
tightened. They can become worn and not tighten properly, in which case they
should be replaced.
Additional Info
For questions and inquiries please email contact@globber.com
WARRANTY
The manufacturer warranties this product to be free of manufacturing defects for a
period of 2 years from the date of purchase. This limited warranty does not cover
normal wear and tear, tires, tubes, cables, or any damage, failure, or loss caused
by improper assembly, maintenance, or storage. This limited warranty will be void
if the product is ever:
• used in a manner other than for recreation or transportation;
• modified in any way; and/or
• rented
The manufacturer is not liable for incidental or consequential loss or damage due
directly or indirectly to the use of this product.
Globber does not offer an extended warranty. If you have purchased an extended
warranty, then it must be honoured by the store at which it was purchased.
For your records, save your original sales receipt with this manual and write the
product name below.
...................................................................................
Spare parts
To order spare parts for this product, please visit our website www.globber.com
7
Publicité
