Publicité
6 Float switch
7 Float switch holder
A Float position for continous operation
8. Placement of the Clear Water Pump
• For use in water wells, the well shaft must have minimum dimensions of 60 x 60 cm, so that the float switch can
move freely.
• Attach a sufficiently strong, water-tight rope to the carry handle to lower the clear water pump, e.g. into a well.
The clear water pump must never be held or attached by the mains cable or the float switch! This may
damage the mains cable; there is danger to life from electric shock! The clear water pump also must not be
attached via the hose.
Fasten the rope to a suitable holder.
Never put the clear water pump with the intake opening into dirt, sludge or leaf residue, e.g. in a rain barrel,
because this will clog the clear water pump. We recommend complying with a minimum distance of 30 cm
above ground.
• To connect the hose used by you to the clear water pump, you may use the enclosed connection piece and the
hose connection.
• There is a cable holder on the side of the carrying handle. It serves to fasten the cable to the float switch.
The activation/deactivation water level will later result from the position in which the float switch cable is attached.
Set the cable length that fits your site of use so that the float switch will switch the clear water pump on and off as
desired.
24
Publicité
