Switching On The Transmitter - Reely SKY Rex-X Nano Notice D'emploi

b) Switching on the Transmitter
Slide the function switch (see figure 1, item 2) from the
left position "OFF" to the right position "ON".
The Power LED (1) and four LEDs in the upper area of
the LED display ring (2) are lit.
If you move the control lever for the pitch function (see
figure 1, item 8) upwards, the 3 LEDs in the lower left
of the LED display ring (3) will start to flash.
When the control lever for the pitch function is back in
the lower position, the four LEDs in the upper area of
the LED display ring (2) will go out, and the three LEDs
in the lower left of the LED display ring (3) are lit con-
tinuously.
The transmitter is now ready for operation.
If the control lever for the pitch function is now pushed
all the way to the top again, all LEDs of the LED dis-
play ring will light up depending on the control lever
position.
Attention!
If the 3 LEDs in the lower left of the LED display ring start to flash during operation, the inserted batteries
are weak and must be replaced.
Figure 3
29