EUROM Flow Pro 550CW Instructions De Service page 19

Insufficient water
Pump does not
start or suddenly
switches off while
functioning
Pump does not
start and stop in
AUTO setting
If these tips do not provide a solution, contact your supplier or service point.
Guarantee
The submersible pump you have purchased comes with the usual guarantee which
applies to production and material defects.
The following damage and defects are not covered by the guarantee:
 Wear and tear and defects in relation to mechanical seals caused by drying out
or the presence of specific substances and/or objects in the water.
 Blockage of the blade by foreign objects
 Transport damage
 Damage caused by unreasonable use
 Defects that unauthorised persons have attempted to resolve or which have
been caused by improper repairs
 Damage due to overheating
The guarantee and liability of the supplier, importer and manufacturer will be
nullified if the pump is opened by unauthorised persons or modifications or
additions are made to the pump.
- Blade is jammed
- Water level is too low
(manual usage)
CW: return valve in
-
pump outlet is blocked
Inlet openings are
-
(partially) blocked
Outlet drain (partially)
-
blocked
Broken fan
-
Thermal safeguard stops
-
pump due to overheating
Water is too hot
-
Power outage
-
Dirt or stones in the
-
water supply
Blade is stuck
-
Problem with the motor
-
Pump is not vertical
-
The float is stuck
-
Try to remove the blockage
-
or ask a professional to do so
Submerge the pump in
-
deeper water
Remove blockage
-
Clean them
-
Remove blockage
-
Replace the fan
-
See: overheating safeguard
-
Max. water temperature 35°C
-
Check fuses and earth
-
leakage
Remove dirt and stones
-
Remove blockage if possible
-
or consult service point
Consult service point
-
Make sure the pump is
-
standing up straight
Clean the float
-
19