Before Use - EUROM Flow Pro 550CW Instructions De Service

Before use

When preparing the device for use, take the plug out of the electrical socket!
Hose connection
Connect the hose connector to the fitting.
The hose connector goes from 25 to 32 mm
(or 1" to 1½"). If you are exclusively using a
more wide hose, you can remove the
remaining piece of the fitting with a sharp
knife or saw. Attach the hose to the
appropriate part of the connector with a hose
clamp (or turn it on it). The best results of
pumping efficiency are achieved with a 32 mm
hose.
Locating and moving
- Make sure the pump is positioned at a stable location, particularly if you want it
to work automatically.
- Ensure that the suction openings are not blocked (not even partially). If the
pump is positioned on a soft surface (e.g. a sand bed), place it on a tile or
something similar.
- Do not use the electrical cable to lift the pump or hang it up. If you wish to
locate the pump in a water source or shaft, use a rope that is attached to the
handle to do so.
- If the pump is being installed into a permanent location, with a fixed drainage
system, you are advised to install a connection point at a handy location in order
to simplify cleaning and maintenance.
- If you are using the pump temporarily, you may use a flexible hose that is
connected to the pump using a hose clamp.
Operation
The electrical cable must be at least a HO5RN-F 3x0.75mm², with a length of at
least 10 metres.
Any extension cable must be of the type HO5RN-F 3x1.5mm².
Before use, check that the values of the socket to which you wish to connect the
pump correspond to those on the type plate on the pump itself (230V-50Hz) and
that the socket is earthed and has an earth leakage circuit breaker (nominal
voltage ≤30 mA). Make sure that no people present in the space to be pumped out
(cellar/boat/pond etc).
Ensure that electrical connections stay dry at all times.
16