Télécharger Imprimer la page

Vitrifrigo VFREE PLUS VFT30 Manuel D'instructions page 21

Publicité

Code F1 displayed
Code F2 displayed
Code F3 displayed
Code F4 displayed
Code F5 displayed
Code F6 displayed
Code F7 or F8 displayed
*For models with FSAK-002 detachable battery, if code F1 displayed, unplug or turn off the battery,
or connect to DC12/24V/AC100-240V(using the adapter) power supply to power the compressor
and battery in time to avoid long-term micro-current draining the battery.
9. WARRANTY
If the device gets malfunctional, limited warranty will be provided for 1 year from the date of
purchase, except following situations:
• Contrived damage.
• Damage caused by force majeure such as earthquake, conflagration, etc.
• Damage from inappropriate use or violating this instruction.
• Damage or malfunction caused by disassembling.
10.TECHNICAL INFORMATION
MODEL
RATED VOLTAGE
RATED POWER
CAPACITY
NOISE
TEMPERATURE SETTING RANGE
CLIMATE CATEGORY
DIMENSIONS (L*W*H)
NET WEIGHT
*Due to product improvement, the technical information might be different from actual
information, please refer to the rating label on the product.
• Possible cause: low voltage to fridge.
Adjust the battery protection from High to Medium or from Medium to Low.
• Possible cause: condenser fan is overloaded. Disconnect power to fridge for
5 minutes & re-start. If the code shows again, contact manufacturer for service.
• Possible cause: the compressor starts too frequently. Disconnect power to
fridge for 5 minutes & re-start. If the code shows again, contact manufacturer
for service.
• Possible cause: compressor not kicking in. Disconnect power to fridge for 5
minutes & re-start. If the code shows again, contact manufacturer for service.
• Possible cause: overheating of the compressor & electronics. Disconnect
power to fridge for 5 minutes & re-start. If the code shows again, contact
manufacturer for service.
• Possible cause: no parameter can be detected by the controller. Disconnect
power to fridge for 5 minutes & re-start. If the code shows again, contact
manufacturer for service.
• Possible cause: temperature sensor is faulty. Contact manufacturer for service.
DC12/24V or AC100~240V(using dedicated adapter) or Solar(12~50V)
631*378*375 mm - 24 7/8*14 7/8*14 3/8 inch
12.8kg /28.2lb (not including battery)
VFT30
60W
27.8L/0.98 cu.ft.
≤45dB
-20~20°C (-4~68°F)
T/ST/N/SN
ENG
21

Publicité

loading