Firmware Updating - Panasonic DMP-BDT100 Mode D'emploi

Network Easy Setting (Internet Connection Test)
Network Easy Setting (Internet Connection Test)
Complete.
- Connection to the Internet : Fail(B019)
Failed the connection test.
Cannot find the server.(B019)
Please refer to the operating instructions for the cause
of the error and the countermeasure for it.
Press [OK].
OK
Display
Cannot find the
server.
(B019)
Failed to connect to
the server.
(B020)
≥ Refer to the operating instructions of the hub or router.
≥ You can perform this setup anytime by selecting "Network Easy Setting"
in the Setup menu. ( 31)
≥ You can redo these settings individually using "Network Settings".
( 31)
≥ Do not use this device to connect to any wireless network for which you
do not have usage rights.
During automatic searches in a wireless network environment, wireless
networks (SSID) for which you do not have usage rights may be
displayed; however, using these networks may be regarded as illegal
access.
≥ After performing network settings on this unit, the settings (encryption
level, etc.) of the Wireless router (Access point) might change.
When you have trouble getting online on your PC, perform the network
settings on your PC in accordance with the settings of Wireless router
(Access point).
≥ Please be aware that connecting to a network without encryption may
result in the content of the communication being illegitimately viewed by
a third party, or the leaking of data such as personal or secret
information.
14
(14)
VQT2U34
Check the following
≥ "Primary DNS" and "Secondary
DNS" settings of "IP Address /
DNS Settings" ( 31)
≥ The server may be busy or the
service may have been
suspended. Please wait a few
moments, and then try again.
≥ Settings of "Proxy Server
Settings" ( 31) and the router

Firmware updating

Occasionally, Panasonic may release updated firmware for
this unit that may add or improve the way a feature
operates. These updates are available free of charge.
This unit is capable of checking the firmware automatically
when connected to the Internet via a broadband connection.
When a new firmware version is available, the following
screen is displayed.
The latest firmware is available.
Please update firmware in Setup.
To update the firmware
Press [FUNCTION MENU]
select "Setup" [OK]
select "Firmware Update"
Now"
DO NOT DISCONNECT the unit from the AC power or
perform any operation while the update takes place.
After the firmware is installed, "FINISH" will be displayed on
the unit's display. Unit will restart and the following screen
will be displayed.
The firmware has been updated.
Current Installed Version: x.xx
≥ If downloading on this unit fails or this unit is not connected to
the Internet, then you can download the latest firmware from the
following website and burn it to a CD-R to update the firmware.
http://panasonic.jp/support/global/cs/
(This site is in English only.)
To show the firmware version on this unit. (
Information")
≥ Downloading will require several minutes. It may take longer or may
not work properly depending on the connection environment.
≥ If you do not want to check for the latest firmware version, set
"Automatic Update Check" to "Off". (
select "To Others" [OK]
select "General" [OK]
[OK] select "Update
OK
RETURN
31, "System
31)