Panasonic DMP-BDT100 Mode D'emploi page 34

Playback
Disc cannot be played.
The disc is dirty. ( 4)
Check the region code. (
The contents of the USB device cannot be
read.
USB devices connected using a USB extension cable
other than the supplied with the Wireless LAN Adaptor
DY-WL10 (optional) or a USB hub may not be
recognized by this unit.
If inserted during playback the USB device may not be
recognized by this unit.
Still pictures (JPEG) do not playback
normally.
The images that were edited on the PC, such as
Progressive JPEG, etc., may not playback.
I can't play back BD-Live.
The SD card is write-protected. (
Confirm that this unit is connected to the broadband
Internet. ( 11)
Confirm the "BD-Live Internet Access" settings. (
Confirm an SD Card is inserted into the SD Card slot.
( 15)
34
(34)
VQT2U34
7)
7)
28)
Network
I can't connect to the network.
Confirm the network connection and settings. (
Check the operating instructions for each device and
connect accordingly.
When using Wireless LAN connection, video
from the DLNA Certified media server is not
played back or video frames are dropped
during playback.
Higher transfer rate router such as 802.11n (2.4 GHz or
5 GHz) Wireless router (Access Point) may solve the
problem. If you use 802.11n (2.4 GHz or 5 GHz)
Wireless router (Access Point), it is necessary to set the
encryption type to "AES".
Simultaneous use with a microwave, cordless telephone
etc. at 2.4 GHz may result in connection interruptions or
other problems.
On the "Access Point Connection Setting" screen
( 31), the continuous lighting of at least 4 "Reception"
indicators is the target for a stable connection. If 3 or
fewer indicators are lit or the connection is being
interrupted, change the position or angle of your
Wireless router (Access point) and see if the connection
state improves. If there is no improvement, connect to a
wired network and perform the "Network Easy Setting"
( 12) again.
11, 31)