Drive Alu Freetec Manuel D'utilisation page 15

10
12
14
16
18
11
13
15
1
2
3
17
Adjusting seat depth
When delivered, the seat depth of all models is 43 cm.
The depth can be adjusted in 4 positions up to 50 cm.
Please open the Velcro straps (Picture 10) and fold the
front piece of the cushion forward. (Picture 11).
In order to adjust the seat depth, please remove the two
screws on the upper tube on both sides (Picture 12) as
well as the 4 screws on the bottom of the wheel receiver
on the left and right. (Picture 13).
You can adjust the frame by pulling it back 3 times to
the next drilling, then insert the screws and tighten them.
Make sure all screws are installed and tightened!
Fold the seat cushion back and fasten the Velcro straps.
Adjusting backrest and cushion
The degree of hardness can be individually and variably
adjusted by the 5 Velcro fasteners (loosen and tighten)
(Picture 14).
In order to mount the back cushion, please lay the cus-
hion on the wheelchair as depicted (Picture 15) and un-
fold it. Part 1 goes on the inside of the backrest, part 2
on the outside (back), and the 3th part goes under the
seat. This will be fixed automatically by the integrated
Velcro straps. (Picture 16+17).
Adjusting height of backrest
The height of the backrest may be adjusted in 4 positions
from 38 cm – 46 cm.
Please note: When adjusting the height of the backrest,
the push handles are adjusted as well.
Loosen the knurled nut on the left and right side (Picture
18), on the bottom of the guide tube attached to the back-
rest. Remove the screws. Adjust the height by pushing or
pulling the push handles into the correct position. Install
the screws and tighten the knurled nut.
Make sure, that both sides are adjusted correctly
and on the same height.
EN
15