stayer L20 Manuel D'instructions Original page 26

machine stopped. The tool emits a warning beep and
does the reverse turn to clean itself.
After cleaning release all buttons and allow the tool to
come to a complete stop for at least 2 seconds
MAINTENANCE
8.
Before any work on the machine (e. g., maintenance,
tool change, etc.) as well as during transport and
storage, set the rotational direction switch to the
centre position.Unintentional actuation of the On/Off
switch can lead to injuries.
For safe and proper working, always keep the machine
and ventilation slots clean.
When the battery is no longer operative, please refer to
an authorised aftersales service agent for Stayer power
tools.
If the machine should fail despite the care taken in
manufacturing and testing procedures, repair should be
carried out by an aftersales service centre for Stayer
power tools.
TRANSPORT
9.
The contained lithium-ion batteries are subject to the
Dangerous Goods Legislation requirements. The user can
transport the batteries by road without further requirements.
When being transported by third parties (e.g.: air transport
or forwarding agency), special requirements on packaging
and labelling must be observed. For preparation of the
item being shipped, consulting an expert for hazardous
material is required.
Dispatch batteries only when the housing is undamaged.
Tape or mask off open contacts and pack up the battery
in such a manner that it cannot move around in the
packaging. Please also observe possibly more detailed
national regulations.
TECHNICAL DATA
10.
= Li-ion battery.
= Voltage
= Battery capacity.
= Battery charging time.
= Free speed.
rpm
= Nylon roll / Dimensions.
= Cutting disc dimensions.
= Weight.
= Sound power level.
= Sound pressure level.
= Vibration.
ENGLISH
26
INFORMATION ON NOISE AND VIBRATION
11.
Noise emission values determined according to
EN 62841-1.
Wear hearing protection.
REPAIR SERVICE
12.
The technical service will provide you advice regarding
questions you may have on the repair and maintenance
of your product as well as on spare parts.
You may also obtain exploded views and information on
spare parts on the internet
DISPOSAL AND RECYCLING
13.
The machine, accessories and packaging should be
sorted for environmental-friendly recycling.
Only for EC countries:
Do not dispose of power tools into
household waste!
According the European Guideline 2012/19/CE
for Waste Electrical and Electronic Equipment
and its implementation into national right,
power tools that are no longer usable must be
collected separately and disposed of in an environmentally
correct manner.
Subject to change without notice.
Battery packs/batteries:
Li-Ion:
Please observe the instructions in section "Transport".
Do not dispose of battery packs/batteries into household
waste, fire or water. Battery packs/batteries should be
collected, recycled or disposed of in an environmental-
friendly manner.
Only for EC countries:
Defective or dead out battery packs/batteries must be
recycled according the guideline 2006/66/CE.
26
under:info@grupostayer.com