Publicité
When using the drill, cooling water is never allowed to get into the
motor and all electrical parts.
Overhead-drillings only with suitable safety measures (water collection).
After an interruption of your work, only switch the machine on again
after having checked that the drill bit can be turned freely.
The tool may be used with the drill rig only.
Do not touch rotating parts.
Persons under 16 years of age are not allowed to use the tool.
During use, the user and other persons standing nearby have to wear
suitable ear protectors, goggles, helmets, protective gloves and boots.
Always work concentrated and carefully. Do not use the tool when
you are lacking in concentration.
For further safety instructions, please refer to the enclosure!
Fixing to Drill Rig
98
79,5
Operate the machine only using a properly grounded
CEE socket (CEE 5-pole 3P+PE 16 A 6h - 400 V).
No water will penetrate the PLD 450 AS as long as it is
Used as intended. This means you can operate it using power directly from
the electrical network. However, since water protection is no longer
guaranteed in the event of damage,
we recommend that an RCD be connected upstream to protect the
operator.
Fasten the gearing foot of the
PLD 450 AS by means of four M 8 Allen
screws to the drill rig.
The drill stand should have a good
stiffness and precise guide ways. The
spindle of the machine needs to go
parallel to the axle of the drill stand.
Use only fall-safe drill rigs.
It is advisable to use a water-collecting
ring.
Electrical Connection
19
Publicité
