Christopeit Sport kinomap VICO Instructions De Montage Et D'utilisation page 17

COMPUTER DESCRIPTION
START-UP
Plug the power supply unit into the power socket and into
a properly connected socket (230V~50Hz). The computer
display briey shows all displays and then switches to the
start display "GO". The quick start program can be started
directly by pulling on the pull rod. All values are counted
in ascending order and you can adjust the resistance as
desired by turning the outer ring of the computer. If training
is interrupted, the display values are saved for 3 minutes
and you can continue training from these display values. The
computer automatically switches to stand-by mode 3 minutes
after training has ended. The display on the computer goes
out and some display values are reset to zero.
OPERATION
There are the following 3 basic functions for operating
the computer:
1. Turn the outer ring to the left or right
2. Briey press the display
3. Long press the display
DISPLAY
After plugging in the power supply, the start screen "GO" for
the QUICK START program is displayed. Briey press calls
up the default programs. Turning a notch calls up the training
programs.
The display has 2 display windows. The upper display shows
the pulse and the strokes per minute alternately every 3
seconds. This display cannot be set to a permanent value.
In the lower display, all other functions are also shown
alternately every 3 seconds. Here, a desired function can be
permanently displayed by pressing the display.
Push
Turn
[SPM]
Shows the number of strokes per minute.
[PULS]
Shows the current pulse rate, but only if an optional
Bluetooth heart rate belt is used.
[TIME]
Shows the training duration in minutes / seconds.
[TIME 500]
Shows the time for 500 meters.
[COUNT]
Shows the rowing strokes.
[DISTANCE]
Shows the distance in meters.
[CALORIES]
Shows the approximate calorie consumption in
Kcal.
[POWER]
No display on the "Vico" model.
[LEVEL]
Shows the current resistance level.
[PROGRAMM]
Shows that a training program is running.
Resistance zone display:
During training, the currently set resistance zone is shown on
the computer display by a colored light ring. The colors are
assigned to the following resistance levels: Blue - Standby
/ LEVEL 1-8; Green - LEVEL 9-15, Yellow - LEVEL 16-23 and
Red - LEVEL 24 - 32.
17
GB