Installation; Inspections On Arrival; Packing And Storing; Selecting The Installation Site And Minimum Operating Area For Indoor Unit - Ferroli OMNIA S 3.2 Manuel D'installation, D'utilisation Et D'entretien

7. INSTALLATION

7.1 Inspections on arrival

Upon receipt of the unit it is essential to check that you have received all the material indicated on the accompanying document, and also that it has not been damaged
during transport. If so, have the dispatcher ascertain the extent of the damage suffered, alerting our customer management office in the meantime. Only by acting in
this way and in a timely manner will it be possible to have the missing material or compensation for damages.

7.1.1 Packing and storing

All machines are packed in cardboard boxes specific for each unit.
The indications required to correctly handle the appliance while storing and
installing it are written on the packing.
The storage temperature must be between -25°C and 55°C.
NOTE
Do not dispose of the packaging in the environment.
Do not dispose of, leave or leave within the reach of children the packaging
material as it may be a potential source of danger.
Once the place in which the unit is to be installed has been chosen (see the rela-
tive sections) proceed as follows to unpack the indoor unit.
Installation requirements
• The indoor unit is packed in a box.
• At delivery, the unit must be checked and any damage must be reported im-
mediately to the carrier claims agent.
• Check if all indoor unit accessories are enclosed.
• Bring the unit as close as possible to the final installation position in its original
package in order to prevent damage during transport.
• The indoor unit weight is approximately 40 kg and should be lifted by two
persons.

7.1.2 Selecting the installation site and minimum operating area for indoor unit

WARNING
There is flammable refrigerant in the unit and it should be installed in a well-ventilated site. If the unit is installed
inside, an additional refrigerant detection device and ventilation equipment must be added in accordance with the
standard EN378. Be sure to adopt adequate measures to prevent the unit from being used as a shelter by small
animals.
Small animals making contact with electrical parts can cause malfunction, smoke or fire. Please instruct the custo-
mer to keep the area around the unit clean.
The equipment is not intended for use in a potentially explosive atmosphere.
• Select an installation site where the following conditions are satisfied and one that meets with your customer's approval.
- Places that are well-ventilated.
- Safe places which can bear the unit's weight and vibration and where the unit can be installed at an even level.
- Places where there is no possibility of flammable gas or product leak.
- Places where servicing space can be well ensured.
- Places where the units' piping and wiring lengths come within the allowable ranges.
- Places where water leaking from the unit cannot cause damage to the location.
- Places where rain can be avoided as much as possible.
- Do not install the unit in places often used as a work space. In case of construction work (e.g. grinding etc.) where a lot of
dust is created, the unit must be covered.
- Do not place any object or equipment on top of the unit (top plate)
- Do not climb, sit or stand on top of the unit.
- Be sure that sufficient precautions are taken in case of refrigerant leakage according to relevant local laws and regulations.
- Don't install the unit near the sea or where there is corrosion gas.
The place of installation must be free of powders, flammable objects or materials
or corrosive gases.
The unit is designed for wall hanging installation and is equipped as standard with
a mounting bracket. The fixing to the wall must guarantee a stable and effective
support.
90
EN
Cod. 3541V941 - Rev. 00 - 09/2021
OMNIA S 3.2
fig. 6 -