Witter FT75U Instructions De Montage

Fitting
Instructions
MATERIALS
A 1 Cross Bar
B 2 M10 Nuts and Lock Washers
C 1 L.H. Bracket
D 1 R.H. Bracket
E 2 M10 x 30 x 1.5p Bolts, Lock Washers and Flat Washers (25mm Diameter)
F 2 M10 x 30 x 1.5p Bolts, Nuts, Lock Washers and Flat Washers (25mm Diameter)
G 2 M10 x 30 x 1.5p Bolts, Lock Washers and Flat Washers (25mm Diameter)
ZE 1 Retractable Electrical
ZB 1 Electrical Plate Bracket
ZN 1 3022 series Neck Kit
FITTING
1. Remove bumper. (1 screw at each tip, 3 screws in wheel arch, 4 plastic clips along bottom edge, 1 top edge at corner of
boot opening. Pull rearwards to unclip. Note: Clips along top edge may be very stiff to release the bumper.)
2. Remove metal bumper beam (Fiat Punto) or Plastic Beam (Alfa Mito)
3. Insert Brackets (C) and (D) into chassis rails and loosely secure with fasteners (E).
4. Loosely attach Cross Bar (A) to rear panel of car, using fasteners (F & B) on the Fiat Punto, or by re-using the
Bumper Beam nuts on the Alfa Mito.
5. Secure to Brackets (C) and (D) to Cross Bar (A) using fasteners (G).
6. Attach the chosen Neck Kit (ZN), Electrical Plate Bracket (ZB) and Electrical Plate (ZE) to Cross Bar (A) using
separate fasteners and instructions from the Neck and Electrical Plate kits.
7. Fully tighten all fasteners.
8. Cut bumper as shown and refit to vehicle.
Note: This towbar must be used with either a Witter Towball (part number Z11) or Class A50-1 or A50-X towball dimensionally
Conforming to A50-1 with a 'D' and 'S' value greater than or equal to that of the towbar.
Please refer to the vehicle specification for the trailer weight and nose limits, which must be observed.
Recommended torque settings: M8 - 27Nm, M10 - 53 Nm, M12 - 95 Nm, M14 - 150 Nm, M16 - 214 Nm
W0001FT75U-FIT$011003250000RÄ
W0001FT75U-FIT$011003250000
TOWBAR
For Fiat Grande Punto 2006-
Alfa Romeo Mito
FT75U
For use
with 3022
series
necks