Preparation - Cembre B15MD Notice D'utilisation Et Entretien

2. INSTRUCTIONS FOR USE
THE BATTERY MUST FIRST BE REMOVED FROM THE TOOL

2.1) Preparation

With the tool in the rest position and without battery, proceed as follows:
Select the appropriate die set for the connector (see Table page 24).
Locate the dies in the head, always inserting the lower one fi rst (with the slot):
1 Press the button (62) and insert the lower die into its seat, then release the button to
lock it in position.
2 Press the button (65) and insert the upper die into its seat, then release the button to
lock it in position.
Dies are uni-positional and cannot be inserted into the wrong seats.
THE LOWER DIE MUST ALWAYS BE INSERTED FIRST
62
2.2) Die advancement
Insert the battery into its seat (Ref. to § 2.8).
Grip the tool fi rmly and comfortably. Position the connector between the dies and ensure the cor-
rect location of the crimp.
Press operating button (4) until the dies are close to the connector without crimping it, then release
the button (4): the connector will be held in position without deforming it.
Make sure the dies are exactly positioned on the desired crimp point otherwise re-open dies
following instructions as per § 2.4 and reposition the connector.
2.3) Compression
– Insert the conductor in to the connector and press the operating button (4): the ram will
gradually move forward until the two dies touch.
It is recommended to keep operating until the maximum pressure valve is activated and
a "click" is heard.
5
WHEN INTRODUCING OR CHANGING DIES,
(Ref. to Figs. 1, 2)
1
LOWER
DIE
slot
65
ENGLISH
2
hole
UPPER
DIE
FIG. 2