5.3.3. STARTING AND STOPPING THE MACHINE
ATTENTION! It is necessary to fill the hydraulic oil tank,
since it is not supplied from the factory. This machine
uses ISO HM22 viscosity oil. See points 6,7 and 8 of
section 7.2.1. CHANGING THE HYDRAULIC'S OIL
1. Loosen the bleed screw until
the air can enter and exit the oil
tank without problems. The flow
of air that out through the bleed
screw hole should be detectable
during operation of the appliance.
If you do not loosen the bleed
screw, the air inside the hydraulic
system cannot leave, thus
compressing itself with every
cutting motion of the bandsaw.
This air pressure can damage the hydraulic system's
seals, causing permanent damage to the machine.
2. Lower the cover of the switches
3. Start the engine by pressing the green button.
5.3.5. CHECKPOINTS AFTER COMMISSIONING
It is important to pay attention to the possible loose
parts or the temperature of the machine. If you
detect any anomaly in the machine immediately stop
and check it carefully. In case of any malfunction or
problem take the machine for service for repaired.
Under no condition should you continue to use the
machine if the operation does not seem appropriate.
5.3.5.1. VERIFICATION OF THE SECURITY SYSTEM
Check that the safety system works correctly by a
testing of the machine without a trunk. To do this,
switch on the engine by pressing the switch and
pushing both the hydraulic control levers at the same
time, the blade will begin its cutting motion. While the
blade is moving stop pressing the left lever and blade
should stop and move back to its original position.
Then perform the same test operation.
If after the test you detect that the machine does
not function as described in this point do not reuse
the machine until it has been reviewed by a service
technician.
5.3.5.2. LEAK VERIFICATION
Check that there are no oil leaks in the machine. If you
detect a leak, take your machine in for service.
5.4. AFTER USE
Once you have stopped using the machine:
1. Disconnect the power source of the machine by
pressing the switch in position "O".
2. Unplug the machine.
3. When you stop using the machine tighten the
bleed screw to prevent oil leakage from the
bandsaw through the trap.
35/120
English