Publicité
$
The charger is intended for
indoor use only.
Read the instruction manual
before use.
Electrical safety
#
Your charger is double insu-
lated; therefore no earth wire is
required. Always check that the
mains voltage corresponds to the
voltage on the rating plate. Never
attempt to replace the charger
unit with a regular mains plug.
If the supply cord is damaged, it must
u
be replaced by the manufacturer or
an authorised Black & Decker Service
Centre in order to avoid a hazard.
Features
This appliance includes some or all of the following features.
1. Safety key
2. Bail bar
3. Lock off release
4. Handle bar
5. Cable restraint clips
6. Upper handle
7. Upper handle quick release clamp
8. Grass box full indicator
9. Grass collection box
10. Lower Handle
11. Lower handle quick release clamp
12. Spring loaded rear door
13. Height adjust handle
14. Battery cover
15. Battery cover release
16. Handle
All manuals and user guides at all-guides.com
Assembly
Warning! Before assembly, make sure that the tool is
switched off and the safety key and battery have been
removed.
Assembling the grass collection box (fig. A - C)
The grass box requires assembly before use and comes in 3
pieces.
u
u
Note: Take extra care when aligning the clips at the rear of the
grass collection box.
u
Fitting the lower handle (fig. D & E)
u
u
u
Fitting the upper handle (fig. F & G)
u
u
Adjusting the height of the handle (fig. H)
u
u
u
Securing the motor cable
The motor cable has to be fixed using the cable restraint.
u
(Original instructions)
Clip the 2 sides of the grass collection box (9) together
(fig.A). Make sure that all clips and guides are aligned.
Align the lid (17) onto the assembled grass collection box.
Ensure that the guides and clips are aligned.
Push down on the lid to secure all clips. Begin at the
front and work towards the back. Ensure that all clips are
securely located.
Remove the lower handle quick release clamps (11) from
the base of the mower.
Place the lower handle (10) around the base, making
sure the three notches (18) on the lower handle (10) face
toward the top.
Screw the lower handle quick release clamps (11) through
the lower handle into the mower base, With the lower
handle quick release clamps screwed in half way, close
the quick release clamps (fig.E) and ensure the teeth of
the handle and base interlock. If the connection between
the handle and quick release clamps is too tight or loose,
adjust the depth of the quick release clamps and close
them again until the teeth are fully closed.
Fit the upper handle (6) to the lower handle (10) using the
upper handle quick release clamps (7) and clamp nuts
(19) as shown.
Screw the upper handle quick release clamps (7) through
the lower handle into the clamp nuts (20), With the
upper handle quick release clamps screwed in half way,
close the quick release clamps (fig. G). If the connection
between the handle and quick release clamps is too tight
or loose, adjust the depth of the quick release clamps and
close them again until the teeth are fully closed.
Release the lower handle quick release clamp as shown.
Lift or lower the handle into one of the 3 marked positions
next to the lower handle quick release clamps.
Close the lower handle quick release clamps (11) and
ensure the teeth of the handle and base interlock. If the
connection between the handle and quick release clamps
is too tight or loose, adjust the depth of the quick release
clamps and close them again until the teeth are fully
closed.
Secure the cable to the upper and lower handle by cliping
it into the cable restraint clips (5)
ENGLISH
11
Publicité
