Publicité
8 | English
(12)
Lock-off function for on/off switch (GGS 30 LPS)
Technical Data
Straight grinder
Article number
Rated power input
Power output
Rated speed
Speed adjustment range
Max. collet diameter
Spanner flat on the
– Clamping nut
– Grinding spindle
Spindle collar diameter
Max. grinding tool diameter
Max. inner shank dimension L
0
Max. shank length
Constant electronic control
Speed preselection
KickBack Control
Restart protection
Soft start
A)
Weight
Protection class
A) Weight without mains connection cable and without mains plug
The specifications apply to a rated voltage [U] of 230 V. These specifications may vary at different voltages and in country-specific models.
Values can vary depending on the product, scope of application and environmental conditions. To find out more, visit
www.bosch-professional.com/wac.
Fitting
Pull the plug out of the socket before carrying out any
u
work on the power tool.
Fitting Abrasive Tools Using an Open-Ended
Spanner and Spindle Lock (see figure A)
Only use open-ended spanners that are suitable and
u
undamaged (see "Technical Data").
– Clean the grinding spindle (3) and all the parts to be fit-
ted.
– Press the spindle lock (13) and turn the clamping nut (2)
by hand until locked.
– Press and hold the spindle lock and loosen the clamping
nut (2) with the open-ended spanner (9) by turning it an-
ticlockwise.
– Insert the straight shank of the grinding tool all the way
into the collet (1).
– Press the spindle lock (13) and tighten the application
tool by placing the open-ended spanner (9) on the span-
ner flat and turning it clockwise.
1 609 92A A80 | (25.11.2024)
(13)
Spindle lock
a) This accessory is not part of the standard scope of delivery.
GGS 30 LS
3 601 BB5 0..
W
750
W
400
−1
min
33000
−1
min
7000–33000
mm
8
mm
17
mm
15
mm
43
mm
50
mm
10
mm
35
●
●
●
●
●
kg
1.7
/ II
The grinding tools must run completely concentrically. Do
not continue to use damaged grinding tools that are out of
balance. If the grinding tools are out of balance, they should
be replaced.
Do not, under any circumstances, tighten the collet
u
with the clamping nut until a grinding tool has been
fitted. The collet may otherwise become damaged.
Only use mounted points with an appropriate shank
u
diameter. A mounting point with a shank diameter which
does not correspond to the tool holder of the power tool
(see "Technical data") cannot be held properly and will
damage the collet chuck.
The application tool must be clamped at least 10 mm.
u
The inner shank dimension L
maximum permitted speed of the application tool from
the specifications provided by the manufacturer of the
application tool. It must not be less than the maximum
speed of the power tool.
GGS 30 LPS
GGS 30 S
3 601 BB5 2..
3 601 BB5 1..
750
400
33000
7000–33000
7000–33000
8
17
15
43
50
10
35
●
●
●
●
●
1.8
/ II
can be used to calculate the
0
Bosch Power Tools
750
400
33000
8
17
15
43
45
10
35
●
●
●
●
●
1.5
/ II
Publicité
