Commissioning; Decommissioning - Renkforce 1210395 Notice D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

8. Commissioning

• After placing the deep-well pump and the connection unit accordingly, plug the mains plug into a proper
mains outlet with ground contact. This must be an IP44 mains socket for operation in the outdoor area.
The mains plug must only be plugged into the mains socket when dry. There is danger to life from
electric shock otherwise!
The mains cable must point downwards from the mains socket so that the water running back at
the cable cannot enter the mains socket.
• Switch on the deep-well pump via the on/off switch (8) at the side of the connection unit. The deep-well
pump will start to take in water and convey it through the outlet opening.
If no water is conveyed, there is still air in the deep-well pump and the hose. You may accelerate the
intake process by mixing the deep-well pump back and forth a little. It would also be possible to fill water
into the hose (switch off deep-well pump first).

9. Decommissioning

• Push the on/off switch (8) to switch off the deep-well pump.
• Disconnect the deep-well pump from the power supply, pull the mains plug from the mains socket.
• Pull the deep-well pump out of the water by the attachment rope.
The deep-well pump must never be pulled out by the mains cable! This may damage the mains
cable; there is danger to life from electric shock!
• Disconnect the hose from the deep-well pump.
• Let residual water run out of the deep-well pump by holding it diagonally or turning it upside-down.
• Dry off the deep-well pump entirely. Coil up the mains cable.
• Store the deep-well pump in a frost-protected and dry room over winter.
Also consider emptying the hoses placed outdoors to prevent frost damage; open any water taps
that may be installed.
• Carry or transport the deep-well pump only by the housing. Never hold it via the mains cable.
• After operation or emptying, a small amount of water may be retained in the deep-well pump. Therefore,
use a suitable support when storing or transporting it in a vehicle.
22

Publicité

Table des Matières
loading

Table des Matières