Publicité
FOR YOUR SAFETY
Be careful when attempting to manually ignite this heater. Holding in the control knob
for more than 10 seconds before igniting the gas will cause a ball of flame upon
ignition.
When the heater is ON:
The flame should be blue with straight yellow tops. If excessive yellow flame is
detected, turn off the heater and consult "Troubleshooting" on page 22.
Re-lighting:
Note: For your safety, the control knob cannot be turned OFF without first depressing
control knob in PILOT position and then rotating it to OFF.
1. Turn control knob to OFF.
2. Wait at least 5 minutes, to let gas dissipate, before attempting to relight Pilot.
3. Repeat the "Lighting" steps on prior page.
FOR YOUR SAFETY
The heater will be hot after use. Handle it with extreme care.
Shut Down:
1. Turn control knob clockwise to PILOT. (Normally, the burner will make a slight
popping sound when extinguished.) Burner will extinguish but PILOT will remain
ON.
2. To extinguish PILOT, depress control knob and continue to turn it clockwise to
OFF.
3. Turn cylinder valve clockwise to OFF and disconnect regulator when heater is
not in use.
Note: After use, some discoloration of the emitter screen is normal.
Publicité
