Publicité
minutes.
2. Inspect the visible portion of the hose before each use of the appliance. If the
hose leaks, it must be replaced prior to operation. Only use the replacement
hose assembly specified by manufacturer.
3. The pressure regulator and hose assembly supplied with the appliance must be
used. Replacement pressure regulators and hose assemblies must be those
specified by the appliance manufacturer.
Lighting:
Note: This heater is equipped with a pilot light that allows for safer startups and
shutdowns. Pilot must be lit before main burner can be started.
1. Turn the control knob to the "OFF" position.
2. Fully open propane cylinder valve.
3. Push control knob in and rotate to pilot position (Figure 1).
Note: For initial start or after any cylinder change, hold the control knob for 2
minutes to purge air from gas lines before proceeding.
4. Push and release the igniter button until pilot flame is visible through
the glass tube.
5. Once the pilot is lit, continue to press the control knob for 30 seconds.
6. If the pilot does not stay lit, repeat steps 4 to 6.
7. If after repeating steps 4 to 6 unit does not light, then
-Push in control knob and turn counterclockwise to "PILOT" (Figure 3).
-As you are depressing the control knob, place long stem lighter through the
glass tube to light the pilot (Figure 4).
-Repeat step 6.
Publicité
