Publicité
NOTE: Whenever gas connections are loosened or removed, you must perform a
complete leak test.
OPERATION INSTRUCTIONS
• CARBON MONOXIDE HAZARD
• For outdoor use only. Never use inside a house, or other unventilated or enclosed
areas. This heater consumes air (oxygen). Do not use it in unventilated or
enclosed areas to avoid endangering your life.
Caution: Do not attempt to operate until you have read and understand all General
Safety Information in this manual and all assembly is complete, and leak checks
have been performed.
This appliance shall be used only in a well-ventilated space and shall not be used in
a building, garage or any other enclosed area.
An appliance may be installed with shelter no more inclusive than:
1)With walls on all sides, but with no overhead cover.
2)Within a partial enclosure which includes an overhead cover and no more than
two side walls. These side walls may be parallel, as in a breezeway, or at right
angles to each other.
3)Within a partial enclosure which includes an overhead cover and three side walls,
as long as 30 percent or more of the horizontal periphery of the enclosure is
permanently open.
Before Turning Gas Supply ON:
1. Your heater was designed and approved for outdoor use only. Do NOT use it
inside a building, garage, or any other enclosed area.
2. Make sure surrounding areas are free of combustible materials, gasoline, and
other flammable vapors or liquids.
3. Ensure that there is no obstruction to air ventilation. Be sure all gas connections
are tight and there are no leaks.
4. Be sure the cylinder cover is clear of debris. Be sure any component removed
during assembly or servicing is replaced and fastened prior to starting.
Before Lighting:
1. Heater should be thoroughly inspected before each use, and by a qualified
service person at least annually. If relighting a hot heater, always wait at least 5
Publicité
