Publicité
ignition.
When the heater is ON:
The emitter screen will become bright red due to intense heat. The color is more visible
at night. The burner will display tongues of blue and yellow flame. These flames should
not be yellow or produce thick black smoke, indicating an obstruction of airflow through
the burners. The flame should be blue with straight yellow tops. If excessive yellow
flame is detected, turn off heater and consult "Troubleshooting" on page 18.
Re-lighting:
1. Turn control knob to OFF.
2. Repeat the "Lighting" steps on prior page.
FOR YOUR SAFETY
The heater will be hot after use. Handle it with extreme care.
Shut Down:
Turn cylinder valve clockwise to OFF and disconnect regulator when heater is
not in use.
Note: After use, some discoloration of the emitter screen is normal.
Operation Checklist
For a safe and pleasurable heating experience, perform this check before each
use.
Before Operating:
1. Be familiar with the entire owner's manual and understand all
precautions noted.
2. All components are properly assembled, intact and operable.
3. No alterations have been made.
4. All gas connections are secure and do not leak.
5. Wind velocity is below 10 mph.
6. Unit will operate at reduced efficiency below 40°F.
7. Heater is outdoors (outside any enclosure).
Publicité
