Publicité
3)Within a partial enclosure which includes an overhead cover and three side
walls, if 30 percent or more of the horizontal periphery of the enclosure is
permanently open.
OPERATION INSTRUCTIONS
Before Turning on the Gas Supply:
1. Your heater was designed and approved for outdoor use only. Do NOT use it
inside a building, garage, or any other enclosed area.
2. Make sure surrounding areas are free of combustible materials, gasoline, and
other flammable vapors or liquids.
3. Ensure that there is no obstruction to air ventilation. Be sure all gas
connections are tight and there are no leaks.
4. Be sure the cylinder cover is clear of debris. Be sure any component removed
during assembly or servicing is replaced and fastened prior to starting.
Before Lighting:
1. Heater should be thoroughly inspected before each use, and by a qualified
service person at least annually. If relighting a hot heater, always wait at least 5
minutes.
2. Inspect the visible portion of the hose before each use of the appliance. If the
hose leaks, it must be replaced prior to operation. Only use the replacement
hose assembly specified by manufacturer.
3. The pressure regulator and hose assembly supplied with the appliance must
be used. Replacement pressure regulators and hose assemblies must be those
specified by the appliance manufacturer.
Lighting:
Lighting:
1. Turn on the valve on the gas cylinder.
2. Press and turn the control knob to HIGH (maximum) position
(counterclockwise 90º). (Figure 1)
3. Holding down the control knob, press the igniter button several times until the
main flame is ignited.
Release the control knob 10 seconds after the ignition.
4. Turn the control knob to LOW (minimum) and leave it there for 5 minutes or
more before turning the knob to the desired temperature setting. (Figure 2)
5. If the burner flame goes out, turn off the heater and wait at least 5 minutes or
more to let the gas dissipate before re-lighting to avoid gas explosion.
Repeat steps 2 to 4.
Publicité
