Publicité
1. Make 2-3 oz. of leak check solution (one part liquid dishwashing
detergent and three parts water).
2. Apply several drops of solution where hose attaches to regulator.
3. Apply several drops of solution where regulator connects to cylinder.
4. Make sure the patio heater and light valves are OFF.
5. Turn cylinder valve ON.
If bubbles appear at any connection, there is a leak.
1. Turn the cylinder valve OFF.
2. If a leak is at hose/regulator connection: tighten connection and perform
another leak test. If bubbles continue appearing, the hose should be
returned to the place of purchase.
3. If a leak is at regulator/cylinder valve connection: disconnect, reconnect,
and perform another leak check. If you continue to see bubbles after
several attempts, cylinder valve is defective and should be returned to
cylinder's place of purchase.
If NO bubbles appear at any connection, the connections are secure.
NOTE: Whenever gas connections are loosened or removed, you must perform
a complete leak test.
• CARBON MONOXIDE HAZARD
• For outdoor use only. Never use inside a house, or other unventilated or enclosed
areas. This heater consumes air (oxygen). Do not use it in unventilated or
enclosed areas to avoid endangering your life.
Caution: Do not attempt to operate until you have read and understand all General
Safety Information in this manual and all assembly is complete, and leak checks
have been performed.
This appliance shall be used only in a well-ventilated space and shall not be used in
a building, garage or any other enclosed area.
An appliance may be installed with shelter no more inclusive than:
1)With walls on all sides, but with no overhead cover.
2)Within a partial enclosure which includes an overhead cover and no more than
two side walls. These side walls may be parallel, as in a breezeway, or at right
angles to each other.
Publicité
