Publicité
6. Unscrew the stainless-steel bolts M6 X 10 (CC) from the head assembly.
7. Unscrew stainless steel bolts M6 x 10 (CC) from the head assembly.
8. Put the upper pole onto the lower pole, using 4pcs. Screw 3/16" (KK) to firmly
secure 2pcs pole. Tighten with a Phillips screwdriver (bring your own). The
warning label on the upper pole should be on the same side as the flat plate of
the lower pole.
Note1: The control knob on head assembly should be above the decal on pole.
When applicable, visually check the portions of the hose assembly located within
the confines of the heater post.
Publicité
