Conrad VC-602 Notice D'emploi page 34

measured and remove all test leads
- switch the unit off (rotary switch to "OFF") and
- with a suitable crosspoint screwdriver, unscrew the fixing scr-
ews in the lower part of the case at the centre top, bottom left
and bottom right.
- Now carefully lever off the cover.
- remove the used battery from the connecting clip.
- replace the battery with a new one of the same type.
- Observe correct polarity (+ and -)
- After replacing the battery place it in the case of the measuring
instrument and carefully close this once more.
- When closing, take care that the connecting clip (red and
black) leads do not become trapped.
Never operate the measuring instrument in an ope-
ned condition! Danger to life!
Do not leave used batteries in the measuring instru-
ment, because even leak-proof batteries can corro-
de and thereby release chemicals, which are both
damaging to health and can destroy the battery
compartment.
Used batteries are to be considered as special wa-
ste and must therefore be disposed of with respect
for the environment. Special collection bins are pro-
vided for this purpose at specialist retailers and in
waste-recovery yards.
B Putting into operation
Operating element - measuring function switch or rotary switch
The measuring instrument is switched both on and off via the rotary
switch.
34