Publicité
All Valentine fryers are fitted with a safety thermostat for each tank. These safety thermostats
are placed in the heating element box at the back of the fryer. The red reset button [15] goes
up underneath the housing.
It is triggered:
when the oil temperature exceeds 230° C
•
when the capillary tube is damaged
•
when the temperature falls below 0° C
•
or when the appliance is not being used properly:
when it is being heated without oil or the oil level is too low
•
when it is being drained without triggering the switch
•
when a block of fat is being melted directly on the heating element
•
To reset the fryer:
• Stop the fryer
• Allow the fryer to cool down
place it on the lid). Until the thermostat bulb [13] attached to the heating element cooled
down, you cannot reset the safety thermostat
• Press down firmly on the red button
Problem
The fryer is not heating.
The fryer is not heating suffi-
ciently
The control lamp does not light
up or flashes
The control lamps light up but
the fryer does not heat up
Other fault
32
Safety thermostat
(thermostat switch [1] to Pos. "0")
Problems and faults
Probable cause
No power
•
Safety thermostat has been
•
triggered
Housing not properly in place
•
One phase is missing
•
Heating element is faulty
•
Faulty control lamp
•
One phase is missing
•
Heating element is faulty or the
•
thermostat is faulty
(to speed this process up lift the heating element and
[15] (until you hear the "click")
Action
Carefully check the fuses, plug
•
and socket
Reset it (see above)
•
Check that the housing is in the
•
correct position
Check the fuses
•
Call the after-sales service team
•
Change the control lamp
•
Check the fuses
•
Call the after-sales service team
•
Call the after-sales service team
•
Publicité
