Publicité
GB
21
CAL1
Default value:
offset of 0°C
Values:
between -5.0°C and 5.0°C
E
J n
Default value: YEs
Values: YEs /no
E
S Ar
31
Default value: YEs
Values: YEs / no
Calibration of external room sensor
This menu is only displayed if parameter rEGU (#30) is set with "Amb".
Calibration must be done after a given order has been operating for a day.
Place the thermometer in the middle of the room at about 1.5 m above the floor.
Record the temperature shown after 1 hour.
07
Enter the reading on your thermometer turning button
21
8
C
°
CAL1
.
Important note:
➤ A large temperature deviation may indicate an inappropriate installation of
the thermostat. If the temperature difference is too big, this could mean your
thermostat was not installed properly e.g. in the right place.
➤ Open window function should not de trigged in any cases if user changes offset
value. This function will be restarted after user validation.
WIN - Open window detection
08
➤ "YEs": activation of function
5
➤ "no": no activation
More information is in paragraph "Opened window detection"
SMAR – Smart scheduled temperature
09
➤ "YEs": activation of function
5
➤ "no": no activation
07
8
C
°
.
The setting is validated with key
J n
no
J n
(adaptive start heating in AUTO mode)
S Ar
31
no
S Ar
31
(step of 0.1°C).
.
E
08
5
08
E
09
5
09
75
Publicité
