Publicité
3. First Installation
See Quick Installation Guide for installation.
3.1 Batteries installation
• Open the cover and insert the 2 AAA supplied batteries.
• Close the cover.
CAUTION: risk of explosion if battery is replaced by an
incorrect type dispose of used batteries according to the
instructions.
3.2 Radio pairing
RF wireless communication initialization:
You must put your receiver or TECE central unit in radio
pairing mode (refer to the device leaflet).
On the back, push 5 sec the button for direct access to
initialization menu.
Following screens are displaying:
rF
. . .
ln t
Other method from parameter menu:
To enter in RF communication initialization mode, user or professional has to:
➤ Enter in "parameter menu" and select parameter rF (see paragraphs "Selection of configuration menu" and "Professional
parameter selection menu");
➤ Press home key
When thermostat is in radio pairing step, it sends bidirectional pairing frames without discontinuity.
During pairing step, there are two cases:
➤ Pairing with receiver: once paired, thermostat automatically exit from initialization phase.
➤ Pairing not finished or not realized (or keyboard inactivity): digital thermostat remains 10 seconds in pairing then
automatically stops.
To reset all wireless parameter (receiver's ID and type), the only method is to clear remote memory.
Resetting the remote is done in "parameter menu" with the parameter EEP (see paragraph "Parameter menus").
IMPORTANT NOTES:
✔ When radio pairing is done, almost all parameters are reset to their factory value with respect of receiver type;
✔ If any pairing wasn't realized, thermostat doesn't transmit any RF frame;
✔ Installer can observe signal power with professional parameter menu (see paragraph "Professional parameter description").
50
Going to wireless initialization menu
rF
. . .
ln t
holding
button
ln t
. Following screen is displaying:
ln t
1
rF
. . . . . . .
ln t
holding
button
rF
48
48
2
3
Initialization
starting
ln t
releasing
button
GB
Publicité
