Publicité
13. Troubleshooting
The table below contains a list of fault symptoms and explains what you can do to remedy the problem if your equipment
fails to work properly. If the problem still persists after working through the list, please contact your nearest service work-
shop.
Important hint in case of sending the equipment to a service station:
Due to security reasons please see to it that the equipment is sent back free of oil and gas!
Fault
Possible cause
Correct starting procedure not followed
Sooted or damp spark plug
The equipment does
Incorrect carburetor setting
not start
Blade or nylon cutter mounted incorrectly
No fuel in the tank
Incorrect choke lever setting
The equipment starts
Soiled air filter
but does not develop
Incorrect carburetor setting
its full power
Cutting blade blunt
Incorrect electrode gap on the spark plug
The engine does not
run smoothly
Incorrect carburetor setting
Incorrect fuel mix
Engine smokes exces-
sively
Incorrect carburetor setting
If the temperature of
Engine is overloaded
machines is too high
32 | GB
Remedy
Follow the instructions for starting
Clean the spark plug or replace it with a new one
Contact an authorized customer service outlet
Reassemble the blade or nylon cutter
Check the fuel level
Set the choke lever on the
Clean the air filter
Contact an authorized customer service outlet
Have cutting blade resharpened /replaced
Clean the spark plug and adjust the electrode
gap, or fit a new spark plug
Contact an authorized customer service outlet
Use the correct fuel mix (see fuel mixing table)
Contact an authorized customer service outlet
Insure the machines have rest at regular time
www.scheppach.com
position
Publicité
