Output Format; Commands - OHAUS a-AB33M1 Mode D'emploi

EN-36
Note:
When printing out dual channel measurement result, conductivity results will be

printed after pH results and they will be shown in the same line.
In continuous mode, "Continuous" will be used for Sample ID.

9.2

Output format

When printed through a printer, the rows of the printing result will be separated and
shown as follows:
The first row: the above item number 1, 2, and 3
The second row: the above item number 4, 5, 6 and 7
The third row: the above item number 8, 9, 10, 11 and 12
The fourth row: the above item number 13, 14 and 15
The fifth row: the above item number 16, 17, 18 and 19
The sixth row: the above item number 20 and 21

10. Commands

Commands listed in the following table will be acknowledged by the meter/analyzer.
Command Characters
SP
LP
PV
PSN
ON
OFF
Table 10-1 Commands
Parameter Function
/ Print when measurement is stable
LP 0 Print calibration result
LP 1 Print measurement result
/ Print version number
/ Print SN number
/ Turn on the meter/analyzer
/ Turn off the meter/analyzer
Analyzer and Bench Meter