Change Password; Records Management - OHAUS a-AB33M1 Mode D'emploi

EN-22
6.2.2

Change password

1. Touch on the screen.
2. Press the
when you see the ID number you want to change password for.
3. Enter the old password. If the old password is correct, the meter will require you to
enter a new password.
Note：
Please refer to the above Switch between different users section for how to

enter password.
If the password is wrong, the meter will require you to re-enter.

4. Then enter the same new password again to confirm. If the modification is
successful, you will see 'Modify Password - Successful' on the screen.
Note: If you enter the new password differently for the two times, the meter will
require you to re-enter the new password.

7. Records management

The meter/analyzer can record 1000 sets of measurement results from 0 to 999.
If the record is full, the oldest record will be automatically overwritten.
To enter records management:
1. Touch on the screen, and then press the
record.
2. Touch on the screen to print the record if you connect the meter/analyzer to
a printer or a computer.
3. Touch again to exit and return to the measurement screen.
Please check the following table for the total number of measurement and calibration
records each model supports.
Maximum Measurement
Model
AB33PH
AB33EC
AB33M1
AB41PH
Note: The calibration records are separate and not included in the 1000 sets of
measurement records.
or button to select between different user IDs. Touch
Table 7-1 Records management
Records
1000
1000
1000
1000
Analyzer and Bench Meter
or
Maximum Calibration Records
1 pH calibration result and 1 ORP calibration
1 conductivity calibration result
1 pH calibration result, 1 ORP calibration
result and 1 conductivity calibration result
10 pH calibration and ORP calibration results
button to view each
result