Sony VAIO VGP-MR100 Série Guide De Démarrage Rapide page 13

2 Connect the Network Media Receiver to a
TV
Note
Make sure that the power cord is not plugged into an AC outlet when you connect the Network Media
Receiver to the TV, or the Network Media Receiver may not operate properly.
Use the supplied audio/video cable to connect the Network Media Receiver to the TV.
The plugs of the audio/video cable are color-coded. Insert each plug into the respective connector.
When using an S-Video cable (not supplied), do not connect the yellow video plug of the audio/
video cable.
S-Video cable
(not supplied)
To S VIDEO
OUT connector
Note
Do not place the Network Media Receiver on top of the TV. Avoid high locations where tension on the
cable could cause the unit to fall.
To video input
1
Audio/video cable
(supplied)
To AUDIO/
VIDEO OUT
connectors
l : Signal flow
VGP-MR100QSG(GB)_2-580-488-11(1)
13