Cleaning, Maintenance And Ordering Of Spare Parts - EINHELL Bavaria BSD 3,6/1 Li Mode D'emploi D'origine

Anleitung_BSD_3_6_1_Li_SPK1__ 15.02.13 11:30 Seite 12
GB
starts as soon as the charging cable is
connected to the charging adapter.
2. The red LED (7) will come on to indicate that the
battery pack is being charged.
3. The charging control lamp (7) goes out when
charging is completed.
Important! The handle may become a little warm
during the charging process. This is normal.
If the battery pack fails to charge, please check
whether there is voltage at the socket-outlet
n
and check for proper contact with the charging
n
contacts in the battery charger.
If the battery still fails to charge, send
the battery charger
n
and the screwdriver
n
to our customer services department.
Timely recharging of the battery pack will help it
serve you well for a long time. You must recharge
the battery pack when you notice that the power of
the screwdriver drops.
6.2 Changeover switch (Fig. 2/Item 10)
The slide switch above the ON/OFF switch is for
setting the direction of rotation of the cordless
screwdriver and for preventing the cordless
screwdriver from being switched on inadvertently.
You can select between clockwise and counter-
clockwise rotation. Change the direction of rotation
only when the equipment is at a standstill. If you fail
to observe this point, the gearing may become
damaged. When the slide switch is in the middle
position, the ON/OFF switch is blocked.
6.3 ON/OFF switch (Fig. 2 / Item 9)
Press the On/Off switch to switch the cordless
screwdriver on. Release the ON/OFF switch to
switch off the tool.
6.4 LED lamp (Fig. 3/Item 2)
The LED lamp (2) can be used in poor lighting
conditions to illuminate the area where you want to
screw.
To switch on, push the switch (4) forwards; to switch
off, pull the switch back again.
6.5 Magnetic screw holder (Fig. 3/Item 3)
Screws can be placed on the magnetic screw holder
for easy reach during operation.
12
6.6 Battery capacity indicator (Fig. 4/Item 5)
Press the button for the battery capacity indicator (6).
The battery capacity indicator (5) indicates the
charge state of the battery on 3 colored LEDs.
All LEDs illuminate:
The battery is fully charged.
The yellow and red LED illuminate:
The battery has an adequate remaining charge.
Red LED:
The battery is empty, recharge the battery.
6.7 Changing the tool (Fig. 5)
Important! Set the changeover switch to its centre
position whenever you carry out any work (for
example changing the tool, maintenance work, etc.)
on the cordless screwdriver.
Insert the bit (a) into the bit chuck (1).
To remove the bit (a), pull it back out of the bit chuck
(1).
6.8 Screwdriving
We recommend using self-centering screws (e.g.
Torx screws, recessed head screws) designed for
reliable working. Be sure to use a bit that matches
the screw in shape and size. Set the torque, as
described elsewhere in these operating instructions,
to suit the size of screw.
7. Cleaning, maintenance and ordering
of spare parts
Always pull out the mains power plug before starting
any cleaning work.
7.1 Cleaning
Keep all safety devices, air vents and the motor
n
housing free of dirt and dust as far as possible.
Wipe the equipment with a clean cloth or blow it
with compressed air at low pressure.
We recommend that you clean the device
n
immediately each time you have finished using it.
Clean the equipment regularly with a moist cloth
n
and some soft soap. Do not use cleaning agents
or solvents; these could attack the plastic parts
of the equipment. Ensure that no water can seep
into the device.