Publicité
Electrical Connection
Before wiring:
• This unit is to be used only in a 12-Volt, DC battery system (Car) with negative ground.
• Remove the covering of the leads about 5 mm long from their end before connecting.
• Disconnect the cable from the negative (-) battery terminal (see note below).
Note;
For installation in cars with trip or navigational computers, all electronic memory settings previously regis¬
tered in the computer will be lost when the battery terminal is disconnected. For this type of car, battery
should not be disconnected. Therefore, extra care should be taken to prevent short circuiting.
• Please read the operating and installation instructions carefully of the respective equipment before con¬
necting to this unit.
Wiring Kit (Option)
--
© Power Cord
-— Cord Standard-
Batt -
use 16 gauge yellow
color wire
GND -
use 16 gauge black
color wire
Amp relay
control - Blue color from the
radio
(2) Speaker Cord (supplied with
the speaker)
CY-M7002EUC
r" Car stereo etc.
^RCA Extension Cord
|
(Option)
\
At Mono Mode
too ST
o**
GAM
R-t/MONO I
&
®:o
Input Connector(RCA Terminal)
Power Indicator
\
RCA Extension Cord
(Option)
©Rubber band for
Fu:
short-circuit prevention
Power Cord
(To battery's (+) terminal)
Ground
Connect to a well grounded
metallic part of your car.
Amp ■ Relay Control Cord
(To car's motor antenna
relay control cord)
18
©Power Cord |
Cutoff Frequency Switching
Level Adjust Volume
Mode Selection Switch
r.*>
r?™, m/DInnl/ C4rirvA
! At Mono Mode j
Gray w/Black Stripe
Sub Woofer
■ Rubber band for short-circuit preven¬
tion
This rubber band is intended to prevent short-cir¬
cuiting between neighboring terminals. Prior to
connection of each lead wire, such wires should
be passed through this rubber band. Since then,
the lead wires may be connected and this rubber
band should be used to wrap the speaker output
terminals, and the power terminals.
Rubber band for short-
circuit prevention
CY-M7002EUC
Publicité
