Publicité
N
Location of Controls
I
s
H
©
E3
1
MONO
«
|
1
1 !■■■■■■
1
©
*
©
POWER MODE
FILTER
MONO ST
off
GAIN
For used in stereo:
® : Right side (+)
(D
: Right side {-)
© : Left side {-)
© : Left side (+)
For used in monaural:
©:(+)
Input Connector
For used when the tape
player/radio's preamp out¬
put connector is an RCA-
type. Remove the insulat¬
ing cap before connection.
O
Fuse(20A)
This fuse is for circuit protection
0
Power Supply Terminal
For connection with the power supply
0
Speaker Output Terminal
For connection with the speakers.
0
Mode Selector Switch
Used for selecting the mode according to this
unit's operating condition.
0
Filter Selector Switch
Used to change the cutoff frequency of sub¬
woofer output.
0
Level Adjust Volume
Used for adjusting the amplifier output level.
O Power Indicator
Lights up when the power of the tape player/radio
connected to this unit is switched on.
© Input Connector (RCA Terminal)
Used when the tape player/radio's output con¬
nector is an RCA-type.
Operation Procedures
For your driving safety, keep the volume level low enough to be aware of road and traffic conditions.
Precautions:
■ This unit is designed to be used with a Panasonic tape player/radio model.
■ This unit is automatically switched on and off if the power switch of the tape player/radio is turned on and
off. The power indicator lights up when the tape player/radio is turned on.
■ Due to its large output, the current consumption of the unit is also large; therefore, the unit should not be
used when the engine is turned off. Otherwise, the battery may deteriorate so that starting of the engine
may become impossible.
■ When using this unit, the speaker cord (supplied with the speaker) must be connected as shown in the il¬
lustration below;
When connecting this unit,
the speaker extension cord's
tip must be peeled off by
using a nipper, etc., as
shown.
Loosen the screw and connect
the tip of the speaker cord on
the unit's speaker output con¬
nector. (Insert and locked.)
4
CY-M7002EUC
Publicité
