Publicité
Problem
The temperature in the appliance is
too low/too high.
Temperature setting LEDs flash at
the same time.
If the problem persists, contact the
Authorised Service Centre.
7.2 Replacing the lamp
For replacing the lamp, contact the
Authorized Service Centre.
8. TECHNICAL DATA
The technical information is situated in the
rating plate on the internal side of the
appliance and on the energy label.
9. INFORMATION FOR TEST INSTITUTES
Installation and preparation of the appliance
for any EcoDesign verification shall be
compliant with EN 62552 (EU). Ventilation
requirements, recess dimensions and
minimum rear clearances shall be as stated
60
ENGLISH
Possible cause
The temperature is not set correctly. Set a higher/lower temperature.
The door is not closed correctly.
The food is too hot.
Too much food is stored at the
same time.
The thickness of the frost is greater
than 4-5 mm.
The door has been opened often.
The FastFreeze function is switched
on.
There is no cold air circulation in the
appliance.
An error has occurred in measuring
the temperature.
7.3 Closing the door
1. Clean the door gaskets.
2. To adjust the door, refer to installation
3. To replace the defective door gaskets,
Voltage
Frequency
in this User Manual in "Installation". Please
contact the manufacturer for any other further
information, including loading plans.
Solution
Refer to the "Closing the door" sec‐
tion.
Let the food cool down before stor‐
age.
Store less food at the same time.
Defrost the appliance.
Open the door only if necessary.
Refer to the "FastFreeze function"
section.
Ensure cold air circulation in the ap‐
pliance. Refer to the "Hints and tips"
chapter.
Contact the Authorised Service
Centre. The cooling system will con‐
tinue to keep food cold, but temper‐
ature adjustment will not be possi‐
ble.
instructions.
contact the Authorized Service Centre.
230-240 V
50 Hz
Publicité
