Publicité
Temperature and humidity display
After inserting the batteries indoor humidity (5)
and indoor temperature (7) will be displayed. Af-
ter fi rst data transmission from the remote sen-
sor the outdoor temperature (9) will be displayed.
This process may take a few minutes.
• You can switch the temperature display from
degree Celsius to degree Fahrenheit by pushing
the DOWN button (17) at the backside of the
wall clock.
• Press the MEMORY button (10) several times to
display one after another the saved maximum,
minimum and current values for temperature
and humidity.
• Press and hold the MEMORY button (10) for ap-
prox. 3 seconds during maximum value display
to delete all saved values.
Mounting/Positioning
NOTE!
Make sure you have mounted or placed the de-
vice in a safe way. Otherwise the device may fall
down and heavy damages can occur for which
the manufacturer is not liable.
The wall clock and the remote sensor can be
mounted on walls with the wall mount (9/16).
Moreover they can be placed on plane surfaces
with the fold-out table stand (14/18).
Troubleshooting
Signal disconnection
If without obvious reasons the display of the out-
door temperature goes blank, please check the
following:
1. The remote unit is still in place.
2. The batteries of both the remote unit and main
unit are not empty. Replace batteries with new
ones if necessary.
GB
19
Publicité
